If your administrator has enabled driver assignments using QR codes, you can sign in to your vehicle using your personalized QR code (for administrator settings, see Driver Assignment Using QR Codes).
To ensure a successful driver assignment, observe the following recommendations when signing in with your QR code:
-
Ensure there is adequate in-cab lighting.
-
If you are using a QR code on your mobile device, adjust your phone display settings to a low to moderate brightness level.
-
If the dash cam does not immediately recognize the QR code, hold the code two inches from the camera and slowly increase the distance by pulling it away. Slowly decrease the distance and repeat as needed until the camera detects the code.
-
Hold the QR code directly in front of the camera lens.
-
Turn the vehicle's engine to the on position.
-
If your administrator has enabled in-cab reminders, wait approximately 30 seconds for the audible prompt to please sign in. When you hear the prompt, position the QR code 2 to 6 inches from the center of the camera and hold the position for approximately 10 seconds. For scanning tips, see QR Code Sign-in Best Practices.
When the sign-in is successful, the camera will alert sign-in successful.
-
If your administrator has not enabled in-cab reminders, wait approximately 30 seconds after you engage your vehicle's engine. Then, position the QR code 2 to 6 inches from the center of the camera and hold the position for approximately 10 to 20 seconds. For scanning tips, see QR Code Sign-in Best Practices.
-
If you did not sign in before driving the vehicle and the in-cab reminders to sign in persist, safely bring the vehicle to complete stop before you attempt to sign in.
